Concept Programming with Quantum and Momentum

Day 1 of 4

Day 3 of 4

Day One focuses on PLC hardware and an introduction to Concept:
• Selection, layout, installation, wiring and configuring of Quantum and Momentum PLC hardware
• Overview of the IEC61131 standard and its implications within Concept
• Introduction to basic Concept procedures, with practical exercise.

Day Three continues to extend the material by including:
• Configuring digital and analogue I/O, programming and animating an SFC
• Connecting Concept to Quantum / Momentum Controller using Modbus, Modbus Plus and Ethernet connections, and downloading the application code

Day 2 of 4

Day 4 of 4

Day Two extends the material from Day One to include:
• The Variables Editor, and Reference Data Editor templates.
• Animation, and Saving programs 
• Programming using the Sequential Function Chart (SFC) language.

Day Four incorporates hands on exercises, including:
• Programming Derived Function Blocks (DFBs) and Macros using the Function Block Diagram editor (FBD), and the simultaneous animation of at least two instances of a single DFB type.
• Using the Concept Controller diagnostic table.
• Troubleshooting